Briefly Describe The Method Of Controlling The Load Bank

While load banks can effectively simulate loads to more easily determine industrial electrical needs, they need to be properly controlled by an expert. Otherwise, it is difficult to obtain accurate results.

The operating procedures for all load banks are somewhat the same, with a few changes here and there. However, if you want to understand the basic concepts of how admins or testers operate them, read the points mentioned here.

Allocate power consumption values

After renting equipment from a company that offers load bank rentals , it needs to be set up. Next, in the test environment, the expert will enter the power consumption value necessary for the system to generate the load and then return to its original state.

It also helps to regulate the temperature of the device during the testing phase. However, each load bank has a threshold. Therefore, operators need to stay within the specified range.

Assign duty cycle command

Setting power consumption values is not enough, administrators also need to assign duty cycle commands to obtain phase-by-phase test results. The command will be based on the specified dissipation value.

After each duty cycle, the load bank will return to neutral or automatically reset to the value. Therefore, expert knowledge is required when entering these values.

Allow and block current flow

If you want to rent a load bank for industrial testing, you need to discuss your requirements with the supplier first so that they can provide you with the correct model that will allow the load tester to control the current efficiently.

After assigning the duty cycle, during the test phase, the tester will need to operate the current and block it appropriately to obtain correct test results. To do this, the tester will remember the maximum and minimum thresholds when the device is in the running phase.

Modify the effective resistance of the load bank

Allowing and blocking current flow will cause a change in the effective resistance of the power supply connected to the load bank. Through this process, the result can be obtained correctly.

To make the necessary modifications, the tester will be available for rent using electronic switches supplied by the company supplying the load bank.

Track the values displayed on the load bank dashboard

During the testing phase, the load bank will display values on the dashboard, which will help the tester determine the power requirements in a typical industrial environment.

Some load banks also offer the option to log the value. Therefore, if this option is available, the tester will record these values for comprehensive analysis to determine the power required in a particular setup.

Operate the load bank using local or remote mode

The tester can also take advantage of local or remote mode power consumption and current modification if the load bank allows it.

Most load banks will come with a manual. So when the setup is the same, the tester may refer to the same to operate it effectively.